WTF

WTFOptional Geared Nut Run-Down

Tentec offer a gear nut run-down mechanism which provides a very rapid and consistent way of seating the foundation hexagon nuts during the tensioning procedure. A common 1/2” Square drive hand torque wrench can be used to rapidly seat the nuts to the recommended 30Nm (max) torque. Alternatively Tentec offer the same foundation tensioning tools but with manual nut run-down.

 

Limited Space OptionsLimited Space Option

A unique elliptical WTF tool is also available for use when clearance between the bolt and tower wall is restricted.

 

 

 

 

 

PhotoAutomatic Tensioner Reset

Again to increase speed all WTF tensioners are fitted with a spring mechanism that automatically resets the tensioner once the pressure has been released to zero. The tensioner is then ready to tension the next bolt, no operator intervention is required.

 

 

 

 

SpecWTF TITLE

Technical Specification

Max Working Pressure = 1350 Bar

 

 

 

Data

Previous Page

Quality Assurance
Tentec are an innovative designer of special purpose bolt tensioning equipment with a high level of focus on quality. The company have accreditation to:-
Tentec products are subject to continual development and Tentec reserve the right to make changes in the specification and design of there products without prior notice. All rights reserved. Reproduction in whole or in part without the permission of Tentec Limited is prohibited.

 XHTML Valid